SUPERIOR FACTORY TYPE 2
DECORATIVE BLACK INSULATION
Superior Factory Type 2 is available with white or custom colors on exposed facing.
Superior Factory Type 2 black insulation also has the following advantages:
- Low in cost
- Covers all roof rafters to give a simi-finished ceiling that never needs paint.
- Is especially beneficial in an exposed rafter application in industrial and commercial
buildings. When installed exposed, below unfaced mineral fiber blanket insulation
or multiple layer aluminum insulation , additional insulation value is achieved.
RECOMMENDED METHOD OF SPECIFYING
Superior Factory Type2 insulation shall be installed only by qualified mechanics.
Face staple Superior Factory Type 2 to bottom of rafters, staples to be approximately 6" o.c. Material shall be installed as a single sheet the full length of the rafters and turned down approximately 1½" at ends where possible, and stapled to both the perlin or main rafter support. Ends shall be neatly trimmed.
Do not install insulation under a roof that is not dry. Insulating a wet roof may cause condensation and damage to insulation and roof deck.
When tested by the ASTM E 84 Flame Spread Test the following results were achieved:
Flame Spread 5 Smoke Developed 15
Superior Aluminum Insulation products are state certified and meet the State of California Quality Standards.